Config::Model::models::LCDd::picolcd - Configuration class LCDd::picolcd
Configuration classes used by Config::Model
generated from LCDd.conf
Sets the initial state of the backlight upon start-up.
Optional. Type
boolean.
- upstream_default value :
- on
Set the initial brightness . Works only with the 20x4 device.
Optional. Type
integer.
- upstream_default value :
- 1000
Set the initial contrast
Optional. Type integer.
- upstream_default value :
- 1000
If Keylights is on, the you can unlight specific keys below: Key0 is the
directional pad. Key1 - Key5 correspond to the F1 - F5 keys. There is no LED
for the +/- keys. This is a handy way to indicate to users which keys are
disabled.
Optional. Type boolean.
- upstream_default value :
- on
Optional. Type uniline.
- default value :
- on
Optional. Type uniline.
- default value :
- on
Optional. Type uniline.
- default value :
- on
Optional. Type uniline.
- default value :
- on
Optional. Type uniline.
- default value :
- on
Key auto repeat is only available if the picoLCD driver is built with
libusb-1.0. Use KeyRepeatDelay and KeyRepeatInterval to configure key auto
repeat.
Key auto repeat delay (time in ms from first key report to first repeat). Use
zero to disable auto repeat.
Optional. Type integer.
- upstream_default value :
- 300
Key auto repeat interval (time in ms between repeat reports). Only used if
KeyRepeatDelay is not zero.
Optional. Type integer.
- upstream_default value :
- 200
KeyTimeout is only used if the picoLCD driver is built with libusb-0.1. When
built with libusb-1.0 key and IR data is input asynchronously so there is no
need to wait for the USB data. KeyTimeout is the time in ms that LCDd spends
waiting for a key press before cycling through other duties. Higher values
make LCDd use less CPU time and make key presses more detectable. Lower values
make LCDd more responsive but a little prone to missing key presses. 500 (.5
second) is the default and a balanced value.
Optional. Type integer.
- upstream_default value :
- 500
Light the keys?
Optional. Type boolean.
- upstream_default value :
- on
Link the key lights to the backlight?
Optional. Type boolean.
- upstream_default value :
- on
Threshold in microseconds of the gap that triggers flushing the IR data to lirc
If LircTime_us is on values greater than 32.767ms will disable the flush If
LircTime_us is off values greater than 1.999938s will disable the flush.
Optional. Type integer.
- upstream_default value :
- 8000
Host name or IP address of the LIRC instance that is to receive IR codes If not
set, or set to an empty value, IR support is disabled.
Optional. Type
uniline.
- upstream_default value :
- 127.0.0.1
UDP port on which LIRC is listening
Optional. Type integer.
- upstream_default value :
- 8765
UDP data time unit for LIRC On: times sent in microseconds (requires LIRC UDP
driver that accepts this). Off: times sent in 'jiffies' (1/16384s) (supported
by standard LIRC UDP driver).
Optional. Type boolean.
- upstream_default value :
- off
Set the brightness while the backlight is 'off' . Works only with the 20x4
device.
Optional. Type integer.
- upstream_default value :
- 0
- •
- cme