ModuleDtmfRepeater.conf - Configuration file for the SvxLink server DTMF
Repeater module
svxlink is a general purpose voice service system for ham radio use. This
man-page describe the SvxLink server configuration for the DTMF Repeater
module.
The DTMF Repeater module retransmits all received DTMF digits. This can be used
to control remote systems that is also DTMF controlled. The DTMF muting
feature should be used on a repeater to not retransmit the received DTMF
audio.
There are a couple of configuration variables that are common to all modules.
The documentation for these can be found in the
svxlink.conf(5) manual
page.
The amplitude, tone length and tone spacing of the generated DTMF digits is
configured in the configuration section for the LocalTx that is actually
transmitting the DTMF. Have a look at the documentation for the
DTMF_TONE_* configuration variables for a full explanation.
Here is the description of all module specific configuration variables that the
SvxLink DtmfRepeater module understands.
- REPEAT_DELAY
- Specify a time, in milliseconds, that the DTMF Repeater
module will wait after digit reception and squelch close before
retransmitting received DTMF digits. If zero or not specified, SvxLink
will try to send the digits as soon as they are received.
This variable does not apply when DTMF digits are sent in non-activated
mode. Digits will then be retransmitted as soon as possible.
-
/etc/svxlink/svxlink.conf (or deprecated
/etc/svxlink.conf)
- The system wide configuration file.
- ~/.svxlink/svxlink.conf
- Per user configuration file.
- /etc/svxlink/svxlink.d/ModuleDtmfRepeater.conf
- Global modularized configuration file. Depends on the
CFG_DIR configuration variable setting.
- ~/.svxlink/svxlink.d/ModuleDtmfRepeater.conf
- Per user modularized configuration file. Depends on the
CFG_DIR configuration variable setting.
Tobias Blomberg (SM0SVX) <sm0svx at users dot sourceforge dot net>
svxlink.conf(5)