ao-load - flash a program to a AltOS device
ao-load [-T
tty-device] [--tty
tty-device] [-D
altos-device] [--device
altos-device] [--cal
radio-calibration]
file.ihx device serial number
ao-load loads the specified .ihx file into the target device flash
memory, customizing the AltOS image with the specified serial number.
- -T tty-device | --tty tty-device
- This selects which tty device the debugger uses to
communicate with the target device. The special name 'BITBANG' directs
ao-dbg to use the cp2103 connection, otherwise this should be a usb serial
port connected to a suitable cc1111 debug node.
- -D AltOS-device | --device AltOS-device
- Search for a connected device. This requires an argument of
one of the following forms:
- TeleMetrum:2
TeleMetrum
2
- Leaving out the product name will cause the tool to select
a suitable product, leaving out the serial number will cause the tool to
match one of the available devices.
- -c radio-calibration | --cal radio-calibration
- This programs the radio calibration value into the image
for hardware which doesn't have any eeprom storage for this value. The
value here can be computed given the current radio calibration value, the
measured frequency and the desired frequency:
- cal' = cal * (desired/measured)
- The default calibration value is 1186611.
ao-load reads the specified .ihx file into memory, locates the matching
.map file and edits the image to customize it using the specified serial
number. It then connects to the specified target device and writes the program
to the target device flash memory.
Keith Packard