NAME
cx — driver for synchronous/asynchronous Cronyx Sigma WAN adaptersSYNOPSIS
To compile this driver into the kernel, place the following line in your kernel configuration file:device
cx
Alternatively, to load the driver as a module at boot time, place the following
line in loader.conf(5):
if_cx_load="YES"
device sppp
options NETGRAPH
options NETGRAPH_CRONYX In /boot/device.hints:
hint.cx.0.at="isa"
hint.cx.0.port="0x240"
hint.cx.0.irq="15"
hint.cx.0.drq="7"
DEPRECATION NOTICE
The cx driver is not present in FreeBSD 13.0 and later.DESCRIPTION
The cx driver needs either sppp(4) or netgraph(4). Which one to use is determined by theNETGRAPH_CRONYX
option. If this option
is present in your kernel configuration file, the
cx driver will be compiled with
netgraph(4) support. Otherwise, it will be
compiled with sppp(4) support.
The base I/O port address specified in
/boot/device.hints must match the port address
set by the jumpers on the board. The DMA I/O channel and interrupt request
numbers are configured by software at adapter initialization. Legal values
are:
- Port:
- 0x240, 0x260, 0x280, 0x300, 0x320, 0x380
- IRQ:
- 3, 5, 7, 10, 11, 12, 15
- DMA:
- 5, 6, 7
HARDWARE
The cx driver supports the following cards:- Cronyx Sigma-22, Sigma-24
- Cronyx Sigma-100
- Cronyx Sigma-400, Sigma-401, Sigma-404, Sigma-410, Sigma-440
- Cronyx Sigma-500
- Cronyx Sigma-703
- Cronyx Sigma-800, Sigma-801, Sigma-810, Sigma-840
SEE ALSO
cp(4), ctau(4), sppp(4), ifconfig(8), sconfig(8), spppcontrol(8)HISTORY
The cx driver was updated in FreeBSD 5.2 and FreeBSD 4.10. In most of the previous versions of FreeBSD the cx driver is out of date. The cx driver for previous versions of FreeBSD is available from http://www.cronyx.ru/.March 2, 2020 | Debian |