vx

NAME

vx — 3Com EtherLink III / Fast EtherLink III (3c59x) Ethernet driver

SYNOPSIS

To compile this driver into the kernel, place the following line in your kernel configuration file: Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

DEPRECATION NOTICE

The vx driver is not present in FreeBSD 13.0 and later. See https://github.com/freebsd/fcp/blob/master/fcp-0101.md for more information.

DESCRIPTION

The vx driver provides support for the 3Com “Vortex” chipset. The medium selection can be influenced by the following link flags to the ifconfig(8) command:

link0

Use the AUI port.

link1

Use the BNC port.

link2

Use the UTP port.

HARDWARE

The vx driver supports the following cards:

• 3Com 3c590 EtherLink III PCI
• 3Com 3c595 Fast EtherLink III PCI in 10 Mbps mode

DIAGNOSTICS

All other diagnostics indicate either a hardware problem or a bug in the driver.

SEE ALSO

arp(4), netintro(4), ng_ether(4), ifconfig(8)

HISTORY

The vx device driver first appeared in FreeBSD 2.1. It was derived from the ep driver, from which it inherits most of its limitations.

AUTHORS

The vx device driver and this manual page were written by Fred Gray <[email protected]>, based on the work of Herb Peyerl and with the assistance of numerous others.

CAVEATS

Some early-revision 3c590 cards are defective and suffer from many receive overruns, which cause lost packets. The author has attempted to implement a test for it based on the information supplied by 3Com, but the test resulted mostly in spurious warnings. The performance of this driver is somewhat limited by the fact that it uses only polled-mode I/O and does not make use of the bus-mastering capability of the cards.

BUGS

The vx driver is known not to reset the adapter correctly following a warm boot on some systems. The vx driver has not been exhaustively tested with all the models of cards that it claims to support.