slaptest - Check the suitability of the OpenLDAP slapd configuration
/usr/sbin/slaptest [
-d debug-level]
[
-f slapd.conf] [
-F confdir]
[
-ndbnum] [
-o option[=value]]
[
-Q] [
-u] [
-v]
Slaptest is used to check the conformance of the
slapd(8)
configuration. It opens the
slapd.conf(5) configuration file or the
slapd-config(5) backend, and parses it according to the general and the
backend-specific rules, checking its sanity.
-
-d debug-level
- enable debugging messages as defined by the specified
debug-level; see slapd(8) for details.
-
-f slapd.conf
- specify an alternative slapd.conf(5) file.
-
-F confdir
- specify a config directory. If both -f and -F
are specified, the config file will be read and converted to config
directory format and written to the specified directory. If neither option
is specified, slaptest will attempt to read the default config directory
before trying to use the default config file. If a valid config directory
exists then the default config file is ignored. If dry-run mode is also
specified, no conversion will occur.
-
-n dbnum
- Just open and test the dbnum-th database listed in
the configuration file. To only test the config database
slapd-config(5), use -n 0 as it is always the first
database.
-
-o option[=value]
- Specify an option with a(n optional) value.
Possible generic options/values are:
syslog=<subsystems> (see `-s' in slapd(8))
syslog-level=<level> (see `-S' in slapd(8))
syslog-user=<user> (see `-l' in slapd(8))
- -Q
- Be extremely quiet: only the exit code indicates success
(0) or not (any other value).
- -u
- enable dry-run mode (i.e. don't fail if databases cannot be
opened, but config is fine).
- -v
- enable verbose mode.
To check a
slapd.conf(5) give the command:
/usr/sbin/slaptest -f //etc/ldap/slapd.conf -v
ldap(3),
slapd(8),
slapdn(8)
"OpenLDAP Administrator's Guide" (
http://www.OpenLDAP.org/doc/admin/)
OpenLDAP Software is developed and maintained by The OpenLDAP Project
<
http://www.openldap.org/>.
OpenLDAP Software is derived from the
University of Michigan LDAP 3.3 Release.